EPUSIL EP 710 AN
Heat Cure Epoxy
Adhesive with High Thermal Resistivity
DESCRIPTION
Epusil EP-710 AN is a two component epoxy adhesive
displaying excellent adhesion to metals, stainless
steel and ceramics. The Epusil EP 710 AN has thermal
shock resistance at high range of temperatures and
its properties avoids any deformation between the
adhesive articles.
PROPERTIES - UNCURED
EP 710 AN (A)
EPC 710 AN (B)
Color, visual
........................................
Red Light yellow
Specific Gravity, g/cm3
........................ 1.84
+/-0.02 1.2 +/-0.02
Viscosity, @ 250 C
…......................... 330-400 Kcps
150-250 cps
Mix Ratio, (Volume)
...........................
100:33
Mix Viscosity @ 250C
………………. 9000-10000 cps
Curing
……………………………….. Heat cure *
(note)
PROPERTIES CURED
Test Methods
Limits
Lap Sear Strength, Al/Al kg/cm2
.............
ASTM-D-1002 175-190
Steel/steel kg/cm2
.....…………………….
225-235
Service Temperature (0C)
........................ `
ASTM-D-794 180
Hardness, Shore D
...................................
ASTM-D2240 85-90
Tensile Elongation (bulk)(%)
...................
ASTM-D-638 3-4
Dielectric Strength
(kV/mm).....................
ASTM-D-149 16
Volume resistivity
(ohm-cm).....................
ASTM-D-257 1014
Dissipation Factor 102 to 1010
Hz..............
0.02 to 0.03
Dielectric constant, 102 to 1010 Hz
.........
3.2 to 2.9
MIXING INSTRUCTION
1.
Warm Epusil EP 710 AN to 35-40 0C and
stir contents thoroughly in the original container
before withdrawing any material.
2.
Weigh out required amount of Epusil EP 710 AN and
weigh into it 33 parts of EPC 710 AN (B) per 100
parts Epusil EP 710 AN (A)
3.
Mix thoroughly scraping sides and bottom of the
container.
4.
Use the compound as need
Curing Schedule:
3-4 hours at 800C, and than 120, 1600
and in accordance for another 3 to 4 hours depend
on the required working temperature .
Printable version |
